FREE STANDARD SHIPPING ON ALL PRODUCTS WITHIN THE 48 STATES.
Couldn't load pickup availability
Keeping a wound site or surgical dressing dry during showering is a practical challenge that SEAL-TIGHT Shield patches solve with a simple, disposable design. Each patch is made from transparent film with a medical-grade adhesive perimeter that creates a waterproof seal around the wound or dressing, allowing the patient to shower normally without getting the site wet. The transparent film allows visual inspection of the wound or bandage without removing the patch, and the paper release liner with release tab makes application and removal straightforward. The 5" x 8" patch provides a 3.5" x 6" coverage area — sized for a wide range of wound sites and dressing configurations. Latex-free. Pack of 5 disposable patches.
How do I apply the SEAL-TIGHT Shield patch?
Clean and dry the skin around the wound or dressing before application. Peel back the paper release liner to expose the adhesive border, center the patch over the wound or dressing with the coverage area fully covering the site, and press the adhesive border firmly onto the surrounding dry skin. Smooth out any air bubbles from the center outward to ensure a complete seal. Apply the patch immediately before showering — do not apply to wet or damp skin, as this will reduce adhesion and compromise the waterproof seal.
How do I remove the patch after showering?
Use the release tab at the edge of the patch to lift one corner of the adhesive border, then peel back slowly and evenly, supporting the surrounding skin as you go to minimize discomfort. Peel in the direction of hair growth where possible to reduce skin irritation. If the adhesive is difficult to remove, moisten the edges with warm water to loosen the bond before peeling. Dispose of the patch after each use — do not reuse.
Can this patch be used over an ostomy appliance or infusion site?
Yes. SEAL-TIGHT Shield patches are specifically designed for use over a range of medical sites including infusion sites, ostomy appliances, catheters, biopsy sites, and laparoscopic procedure sites in addition to standard wound dressings. The 5" x 8" patch size and 3.5" x 6" coverage area accommodate most standard dressing and appliance configurations. For larger ostomy appliances or dressings that extend beyond the coverage area, a larger waterproof cover may be more appropriate.
Is one patch sufficient for a full shower?
Yes. Each patch is designed to maintain its waterproof seal for the duration of a normal shower when applied correctly to clean, dry skin. The medical-grade adhesive perimeter creates a secure seal that resists water penetration during showering. Prolonged soaking in a bath or hot tub is not recommended — the patch is designed for shower use, not extended water immersion. Each patch is single-use and should be discarded after showering.